
Getting your car ready for the ski resort: a step-by-step guide to fitting snow chains
How should you prepare your car to drive safely on snowy mountain roads? In our video we show you step by step how to fit snow chains, along with winter driving techniques.
As ski season opens, traffic on mountain roads gets heavier. But drivers who head onto snowy roads unprepared not only put their own safety at risk but can also bring traffic to a halt. In our video we list everything to do before setting off, from checking winter tires to antifreeze levels. We also show step by step how to fit snow chains in a few minutes and the driving techniques that keep you in control on snowy slopes.
In this article
- Checklist before you set off
- How to fit snow chains
- Driving techniques for snowy hills
Checklist before you set off
Before heading up to a ski resort, the first check should be the condition of your winter tires. If the tread isn't deep enough or the tires are old, even chains may not be enough. Measure tire pressure again in the cold; as the temperature drops, so does the pressure. Keeping the fuel tank at least half full helps you stay warm if you get stuck in traffic. In cold weather, small preparations make a big difference.
The antifreeze level and using winter-grade washer fluid are also critical. Testing the battery in the cold, replacing the wiper blades and checking the headlights are other items on the list. The car should carry snow chains, gloves, a flashlight, a small shovel, a blanket and an ice scraper. Make sure the chains match your car's tire size.

Try fitting your chains for the first time in your driveway, not on the side of a snowy road.
Sarah Bennett
How to fit snow chains
Before fitting chains, find a safe, level spot, switch on your hazard lights and apply the parking brake. Take out the chains, lay them on the ground, untangle them and place them in front of the wheel they'll go on. Chains usually go on the drive wheels: the front wheels on front-wheel-drive cars and the rear wheels on rear-wheel-drive cars. Always check the owner's manual.
The chain is passed behind the tire, joined at the front and tightened with the tensioner. After driving a few meters, you need to stop and check the tension again. With chains on, speed shouldn't exceed 30 km/h (20 mph). Practicing in your driveway before you hit the snow reduces the chance of mistakes and saves time. These simple steps save you unnecessary stress when time is short.
Driving techniques for snowy hills
The technique for driving up a snowy hill is simple but takes discipline. Before starting the climb, it's important to keep your momentum, not lift off the throttle suddenly and not change gear. If possible, drive in a higher gear with gentle throttle. Leave enough distance to the car in front; a car that stops on a hill can bring the one behind it to a halt too. This rule matters for both safety and traffic flow.
| Topic | Road & Travel |
|---|---|
| Highlights | winter tires, travel, SUV |
| Reading time | 4 minutes |
| Written by | Sarah Bennett |
Key takeaways
- Check tires, antifreeze, battery and equipment before you set off.
- Fit chains to the drive wheels on a safe, level spot.
- Keep your momentum on snowy climbs and use engine braking on the way down.
On the way down, use a low gear to bring in engine braking and avoid stamping on the brake pedal. If the car starts to slide, steer in the direction of the slide and don't suddenly floor the throttle. Keep your distance from any cars waiting at the roadside. The best preparation, though, is to try out your chains at home before ski season starts.
What do you think about this post?



































































Leave a comment